SAW Utility Pack Digital Audio Plug-ins Description:

The Meter Bridge contains PEAK Style meters for monitoring any or all channels in SAW. You can select either STEREO or MONO mode, where MONO mode shows only one meter and takes much less room on the desktop.

The SE Meter Bridge is a Peak Type meter bridge for SAW. It displays the current loudness in "dB" of each stereo channel in the multi-track.
You can select either STEREO or MONO mode, where MONO mode shows only one meter and takes much less room on the desktop.
It allows you to NAME a track for easier identification.
There are two viewing scales, Linear and Logarithmic.
You can select from three "Peak and Hold" options, SHORT, LONG, and INFINITE. The Meters will hold the latest peak amplitiude and then decay down to -inf dB.
Also a Hard Clip option which will stop any overs from occurring. If you are using SAWPro then it can display digital overs above 0 dB. You can use the Peak value displayed here as a guide to either reduce or increase the track's amplitude.
Also a "RESET ON RE-CUE" option which will reset the meter to -infinity. You can reset the meters by clicking the dB read out above the meters.
The Aux Send Return plug-in is a plug-in which allows you to send audio from one track and return on another track. This is very similar to what is found on most analog mixers. One of the advantages for the Aux Send plug-in is you can use a single Reverb for more than one track. This greatly reduces the CPU load. Use can also use it for virtual mixing (amplitude only).